
Install summary
The goal in this case was to produce the highest fidelity home theater experience combining new and exisiting hardware.
System
Some gear below links to a retailer. If you buy through those links I may earn a commission at no cost to you. Details.
Layout7.2.4
- Front L/R
- Revel f206×2
- Center
- Vienna Acoustics
- Surround
- Vienna Acoustics×2
- Height / Atmos
- Sonance
- Subwoofer
- Rythmik F12, Emotiva 12"
- Receiver / processor
- Anthem MRX 740
- Projector
- Epson 5040UB
- Screen
- 150" 16:9 Silver Ticket Thin Bezel Screenaffiliate link
- 4K Blu-ray Source
- Sony UBP-X700
- Streaming Source
- Apple TV 4K
- Dolby Vision Spoofer
- EZCOO SP12H2
Challenges
- 01
Projector Format Support
Epson 5040UB did not support Dolby Vision
Solution The Epson 5040 UB is a 10 year-old projector and as a result of that it does not support Dolby Vision and does not even have HDMI 2.1 so we added an HDMI spoof for between the sources and the projector so that the Blu-ray player or the Apple TV 4K could tone map, Dolby Vision and send a more detailed and vibrant picture to the projector. We had to flash new firmware on the EZCOO SP12H2 to make this happen.
- 02
Projector Color Calibration
Epson 5040UB displayed crushed blacks on HDR scenes
Solution the Epson 5040UB while having its strength in the brightness department was not able to accurately retrieve enough detail from shadows in dark scenes and it made HDR scenes look quite doll so we went through around eight hours of calibration to bring this projector up to its best possible potential. This did mean that we could not use the digital cinema setting on this projector as it would reduce the amount of light that the projector could throw onto the screen even though it covers around a greater percentage of the BT.2020 color gamut. But since most movies are actually mastered in DCI P3, bright cinema and natural were perfect for this cinema use case.
